Gallery
Description
Features
Specs
Reviews
Q&A

Videos (2)

View Allarrow icon
Dan Explains It All - Excess V2play button

Dan Explains It All - Excess V2

OBNE Presents: Excess V2play button

OBNE Presents: Excess V2

Old Blood Noise Endeavors

collapse expand iconDescription

The Old Blood Noise Excess V2 modulated distortion effects pedal continues their journey to revive and expand sought-out pedal sounds of the ’80s. It features three modes of modulation—Delay, Chorus and Fifth—each with Time, Depth and Volume controls. The Distortion section includes Gain, Tone and Volume controls, allowing you to access light overdrive through fuzzy distortion. Experiment running Distortion into Modulation, Modulation into Distortion or the two in separate parallel paths. The Excess V2 also includes soft touch switching and true relay bypass for each section, an expression jack to externally control Rate and Depth, and an internal trimpot to set wet-dry mix of the Modulation section.
Old Blood Noise Endeavors Excess V2 Modulated Distortion Effects Pedal Pink
Old Blood Noise Endeavors Excess V2 Modulated Distortion Effects Pedal Pink
Old Blood Noise Endeavors Excess V2 Modulated Distortion Effects Pedal Pink

collapse expand iconFeatures

  • Three modes of modulation (Delay, Chorus, and Fifth) each with Time, Depth, and Volume controls
  • Distortion section with control over Gain, Tone, and Volume
  • Order switching to run Distortion into Modulation, Modulation into Distortion, or separate parallel paths
  • Soft touch switching and true relay bypass for each section
  • Expression jack to externally control Rate and Depth
  • Internal trimpot to set wet-dry mix of Modulation section

collapse expand iconSpecs

  • Requires at least 125mA 9VDC center negative power
  • Note: Expression Ramper is initially configured for TRS active at Tip for compatibility with Old Blood devices, but can be configured for TRS active at Tip, TRS active at Ring and TS using the internal jumpers. By default, it ships with a 50K digital potentiometer. This potentiometer is socketed and can be replaced with 10K and 100K values if needed (part code MCP41010-I/P and part code MCP41100-I/P respectively)

Featured Articles

collapse expand iconReviews

Be the first to review the Product

collapse expand iconQ&A

Have a question about this product? Our expert Gear Advisers have the answers.

No results but…

You can be the first to ask a new question.

It may be Answered within 48 hours.