Gallery
Description
Features
Specs
Reviews
Q&A
Waves

Description

The engineering brains at Waves and Paul Reed Smith guitars have put their heads together to create this high-quality interface which transforms your unbalanced high impedance guitar signal into a balanced low impedance signal, reducing hum and retaining your full dynamic range. The result is ultra-high fidelity at the most critical point in the signal path. The compact black box features studio-grade jacks, a large Gain knob, LED indicators for level, low battery, and power. It's transparent pre-amp and custom-designed circuitry are just what you need when you're ready to lay down your hot new guitar licks.
Waves PRS Guitar Interface

Features

  • Transparent pre-amplifier
  • Custom-designed circuitry
  • Audiophile-quality components
  • Studio-grade balanced and unbalanced jacks (one XLR and 1/4" TS jack each)
  • Micorophone/line level outputs
  • Gain knob
  • LED lights to indicate signal present, nominal level, and over

Specs

  • Dimensions: 9.5cm (W) x 4.3cm (H) x 11.5cm (D)
  • Weight: 356g
    • TRS input
    • Input impedance:
      >1 Mega Ohm unbalanced
    • Max input level: 1.1 VRMS.
    • Power saving switch: Automatic shut down when input jack is not connected
    Balanced XLR input
    • All measurements were performed with volume at a nominal setting
    • Output impedance: 50 ohm
    • S/N: >105 at line level, (S measured at 1%, 1kHz, A-weighted)
    • Response: 20-20kHz, -3dB @ 11kHz, -5dB at 20kHz
    • THD+N: <0.005 (< -90dB) at -10dB below max sensitivity level
      Sensitivity: 1.1Vrms at line level, 2.5 Vrms at mic Level
    • Gain: 11dB at line level, -28dB at mic level. ±1.5dB
    • Volume range: +5dB, -10dB refer to nominal setting
    • Output short circuit protection: Ground lift switch
    • Power: Two 9V Batteries, 12-18V DC, 0.5A minimum
    Unbalanced PL Jack output
    • All measurements were performed with volume at a nominal TD setting
    • Output impedance: 50 ohms
    • Output impedance: 100 ohms
    • S/N: >105 at line level, (S measured at 1%, 1kHz, A-weighted)
    • Response: 20-20Khz, -3dB at 11kHz, -5dB at 20kHz

    Reviews

    5

    1 Reviews

    0%

    of respondents would recommend this to a friend

    Reviewed by 1 customers

    • Works Great

      5

      submitted16 years ago

      byDigi Dan

      fromNew York

      This box works great, using it with a xlr to trs output cable results in a significant improvement in frequency range and dynamics compared to plugging straight into a hi-z input on a Digi 003. I A/B tested it and found it restores a lot of high frequencies and clarity. Only thing is it doesn't come with a power cord, only batteries, going to have to buy a power cord somewhere else for it. Great for recording direct into a DAW.

    • Previous
    • 1
    • Next

    Q&A

    Have a question about this product? Our expert Gear Advisers have the answers.

    No results but…

    You can be the first to ask a new question.

    It may be Answered within 48 hours.