Gallery
Description
Features
Specs
Reviews
Q&A

Videos (1)

View All
Chrismas party using Peavey Triflex

Chrismas party using Peavey Triflex

Peavey

Description

The Triflex II is a 1000 Watt three piece, two-channel sound system, already tweaked and ready to go for sound reinforcement, DJ gigs, and various music playback duties. Consisting of a shared Subwoofer cabinet and a pair of Satellite speakers, the system has been pre-engineered for a balanced sound and a crisp, punchy presentation. The three-way effective performance that the system is capable of provides a clear sound at high output levels, with plenty of punchy bass.
Peavey TriFlex II 1000W Three-Piece, Two-Channel Sound System

Features

  • 1000W Active Two-Channel Three-piece Speaker System
  • One shared Subwoofer cabinet which houses the inputs and power amps
  • Two two-way Satellite speakers with speaker pole stand adaptors
  • Subwoofer has 15" woofer, with 500W peak available power
  • Satellite speakers have 10" woofer, RX 14 1.4" compression driver tweeter
  • 250W peak available power to each Satellite speaker
  • Peavey's exclusive DDT compression on the Satellite power amps
  • System comes with two 15 foot speaker cables
  • Protective slipcover with cable storage pockets and built-in Velcro retaining straps
  • Heavy-duty locking casters on Subwoofer cabinet for transport of system
  • Satellite speakers nest on top of the Subwoofer, help ease transport
  • Four-pin twist-lock connectors on amplifier outputs and Satellite inputs
  • ***Speaker stands sold separately***

Specs

  • SUBWOOFER:
  • Transducer complement: 1 x 15" woofer
  • Nominal Impedance: 8 ohms
  • Power Handling, Transducer: 350W Continuous, 700W Program
  • Box tuning frequency (Fbox): 48 Hz
  • Frequency Response, 1 meter on-axis, swept-sine in anechoic environment (thru
  • system electronics): 40 Hz to 105 Hz
  • Usable low frequency limit (-10 dB point): 34 Hz
  • Sound Pressure Level, 1 Watt, 1 meter in /2 space environment: 102 dB
  • Maximum Sound Pressure Level (1 meter, 1 / 2 space): 127 dB
  • Weight: 98 lbs. (44.5 kg)
  • Dimensions (H x W x D): 19.65" X 28.00" X 28.10" (Includes feet)
  • (unit down on feet) 19.65" X 32.00" X 28.10" (Includes feet and casters)
  • Height in Transport mode: 32.00"
  • SATELLITE SPEAKERS:
  • Transducer complement: Low Frequency Section: 1 x 10" woofer
  • High Frequency Section: 1 x 1.4" titanium compression driver on a Quadratic Throat
  • Waveguide with 75 degrees by 75 degrees coverage pattern
  • Nominal Impedance: 4 Ohms
  • Power Handling, Satellite System: 200W
  • Continuous, 400W Program, 800W Peak
  • Box tuning frequency (Fbox): 84 Hz
  • Frequency Response, 1 meter on-axis, swept-sine in anechoic environment: 88 Hz to 20 kHz
  • Sound Pressure Level, 1 Watt, 1 meter in 1/2 space environment: 101 dB Maximum
  • Sound Pressure Level (1 meter, ½ space): 124 dB
  • Weight: 24 lb
  • Dimensions (H x W x D): 19.6" X 11.83" X 11.83" (Upright, Includes feet)
  • COMPLETE SYSTEM:
  • Active Crossover Frequency: 120 Hz, 24 dB/Octave
  • Maximum Sound Pressure Level (1 meter, half-space): 129 dB
  • Dimensions when in transport orientation, on casters (H x W x D): 43.00" X 20.37"
  • X 23.54" (Includes all feet)
  • Weight (Sub and Satellites Only): 146 lb
  • Speaker Cables: Two 15 foot 16 ga. With 4-pin twist-lock connectors on each end.
  • INTERNAL AMPLIFIER:
  • Subwoofer Amp Power Output: 500W peak available power 250W continuous, into 8 ohms.
  • Satellite Amps Power Output: 250W peak available power 125W continuous, into 4
  • ohms.
  • Inputs (Line Level): Left channel XLR or 1/4" phone jack combo input (female)
  • Right channel XLR or 1/4" phone jack combo input (female)
  • Input Impedance: 20 k Ohms balanced, 10 k Ohms unbalanced (single-ended)
  • Thru (Outputs, Line Level): Left channel XLR full-range output (male), Right channel
  • XLR full-range output (male)
  • Speaker Level Outputs: Left channel 4-pin twist-lock professional connector, Output
  • Right channel 4-pin twist-lock professional connector Output
  • CONTROLS:
  • Master System Level (Left & Right Gain)
  • Subwoofer Level Control, Ground Lift Switch, Power Switch (On rear of amp panel when the Subwoofer is in use position, with rubber feet on the floor)
  • Nominal amplifier frequency response: +0, -2 dB from 10 Hz to 20 kHz
  • Hum and noise: Greater than 90 dB below rated power
  • DDT dynamic range: Greater than 18 dB
  • THD: Typically less than 0.05 %
  • Infrasonic filter protection: 36 dB/octave roll-off
  • Power Requirements: Domestic 120VAC, 60 Hz, 210 Watts
  • Weight Unpacked: 159.83 lb(72.5 kg)
  • Weight Packed: 199.52 lb(90.5 kg)
  • Width Packed: 30.5"(77.47 cm)
  • - Height Packed: 53"(134.62 cm)
  • - Depth Packed: 24.5"(62.23 cm)

Reviews

5

3 Reviews

100%

of respondents would recommend this to a friend

Filters
Best Uses
  1. Home Studio1
Describe Yourself
  1. Experienced1
Pros
  1. Compact1
  2. Easy To Use1
  3. Good Audio1
  4. Versatile1

Reviewed by 3 customers

  • Awesome item I am so happy

    5

    Verified Buyer

    submitted10 years ago

    byMike

    fromAngleton tx

    Again this is a amazing system and I will buy another one on the fu

  • Peavey Triflex

    5

    submitted11 years ago

    byCARLOS

    fromGarland Texas

    I been having this unit for more than 3 years. I am very impressed and would reccommend this product to anyone that asked for my opinion.

  • peavey lives up to it's name

    5

    submitted12 years ago

    byDave Cross

    frombaltimore, md

    I did some research on a lot of these powered systems, I even heard some of them live, most of them had poor bottom end especially playing songs with heavy bass, they would flutter, after reading up on the Triflex I knew this was the right system for me. Peavey always made great speakers ( Black Widow ) I have owned previous models made by Peavey( FH1 ) they had a strong bottom end with no distortion. The name speaks for it self. The other brands I'm not going to knock, but it is what it is. I only have one flaw with the systen, they should have been made out of plywood instead of ODC, but I have had speakers made with the same ODC back in 1989 and they are still holding up.I have been in the DJ business for 30 years plus so I'm familiar with sound these are a great buy for the price.

  • Previous
  • 1
  • Next

Q&A

Have a question about this product? Our expert Gear Advisers have the answers.

No results but…

You can be the first to ask a new question.

It may be Answered within 48 hours.