Gallery
Description
Features
Specs
Reviews
Q&A
Crown

Description

1,050W/ch @ 2 ohms, 800W/ch @ 4 ohms, 500W/ch @ 8 ohms, 1,600W bridged mono @ 8 ohms. Designed to provide the quality, power, and reliability you expect from other Crown amps with many of the same controls and features for a much friendlier price.

Features sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use.
Crown XLS 802D Power Amplifier
Crown XLS 802D Power Amplifier

Features

  • Features sophisticated protection circuitry
  • 5-way fault indicator
  • Red peak clip LED on each channel
  • Green signal-present LED that flashes when the level is extremely low
  • Detented level controls
  • Mode select switch for stereo or bridged
  • 3-speed fan
  • XLR inputs
  • Touchproof binding post and Speakon outputs
  • All in a rugged steel chassis designed to handle serious road use
  • 3-year no-fault warranty
warning

WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov.

Specs

  • Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V.
  • Frequency Response (at 1 watt) 22Hz to 20kHz: +0 dB, ”0.8dB
  • Signal-to-Noise Ratio (20Hz to 20kHz)_A-weighted, below rated power: _
    >98dB. _No weighting, below rated power: _>93dB.
  • Total Harmonic Distortion (THD):
    <0.5%.
  • Intermodulation Distortion (IMD):_(60Hz and 7kHz at 4:1) from full rated output to ”40 dB: < 0.3%.
  • Damping Factor (8 ohm) 10Hz to 400Hz: >200.
  • Crosstalk (below rated power)_at 1kHz: ”76dB. at 20kHz: ”58dB.
  • Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced.
  • Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.
  • AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60Hz, 100 VAC 50/60Hz, 220 VAC 50Hz, and 230-240 VAC
  • 29 lb.

Reviews

4.25

8 Reviews

0%

of respondents would recommend this to a friend

Reviewed by 8 customers

  • This amp rox

    5

    submitted16 years ago

    byLisa

    fromDallas, Texas

    Crisp, clear sound with solid separation, exactly what I was looking for!

  • 802D

    5

    submitted16 years ago

    bycq clemmings

    fromWI

    Basic amp sounds like what you want with right processing. Very clean and simple inside, I bought this to replace Behringer, should last as long. Works at 2 ohms but don't push it on low end, I use B52-4000 for that.

  • Doesnt do near what it says. Very weak

    1

    submitted16 years ago

    byC. Collins

    fromDallas, TX

    I bout one of these to run on a carvin sub that was 1600 peak. ran it bridged and it wouldnt push at all hardly without clipping. Had a sound enginneer come in and said this is one of the worst amps crown has prroduced. Crown is a good amp, but this particular model is a flop.

  • CROWN Amps are SOLID!

    5

    submitted16 years ago

    byDJ TMAQ

    fromCharlotte, NC

    I bought this amp, and doing events with it without a carrying case. After one event, I was pushing my cart (loaded with 2 speakers/turntables/mixer/THIS CROWN AMP) onto an elevator and the wheel caught to gap at the elevator and my cart stopped instantly throwing my mixer and this amp smashing to the marble floor. The fall bent the metal casing this amp is built into. I got home, hook everything up and WOW!! IT STILL WORK AMAZING! No volume or static issues after that nasty fall. This CROWN is durable, and pushes my 2 15' JBL with ease. I also left it on over night after performing all evening and came back to the venue the next day find it running cool and quiet. Don't Hesitate to purchase a CROWN.

  • packs a powerful punch

    5

    submitted17 years ago

    byEdson

    fromDelano,CA

    this amp is worth the price.we have a little band and with two of these is good enough for about 200-350 people.this amp can keep up with the long hours and still pack a powerful punch.if your looking for a good amp for a small gig...this is the one for you(depends on the system your running)

  • Powerful Amplifier

    4

    submitted17 years ago

    byFisher

    fromSeattle, WA

    I bought this amplifier about a month ago, and I am happy with it so far. Very Powerful in Bridge mode. Huge bass response. I love the quality. The only thing I wish different was pre outs on the amplifier so I can daisy chain more together (for subs) instead of just one input, like the Xti models.

  • Previous
  • 1
  • 2
  • Next

Q&A

Have a question about this product? Our expert Gear Advisers have the answers.

No results but…

You can be the first to ask a new question.

It may be Answered within 48 hours.