For proper string alignment and balanced output, F-spaced humbuckers should be used in the bridge position on all guitars with string spacing at the bridge of 2.1" (53 mm) or greater. On these guitars, if the nut width is 1-11/16 (43 mm) or greater, F-spaced pickups can be used in the neck position as well.The D Activator Bridge has an enriched ha... Click To Read More About This Product
Find a similar product below or contact us for a recommendation of a great alternative.
For proper string alignment and balanced output, F-spaced humbuckers should be used in the bridge position on all guitars with string spacing at the bridge of 2.1" (53 mm) or greater. On these guitars, if the nut width is 1-11/16 (43 mm) or greater, F-spaced pickups can be used in the neck position as well.
The D Activator Bridge has an enriched harmonic quality and the notes want to sing. Both the D Activator Neck and Bridge pickups were designed to eliminate the sterile edginess commonly associated with active pickups. The D Activator Bridge pickup is about 25% louder than the D Activator Neck. Since they were developing both pickups as a set from the ground up, DiMarzio adjusted the volume levels on the pickups so they are balanced. That way when you switch from the neck to the bridge, you don™t hear a drop in volume ” also a frequent problem with active pickups ” and they don™t use batteries.
NOTE: Recommended for bridge position.
An interesting fact about the most popular active bridge pickups is that they aren™t incredibly loud. Instead, they have a strong, focused attack that hits the amp very hard and makes them ˜feel™ more powerful than they actually spec out to be. This is an important characteristic that DiMarzio needed to capture with the D Activator bridge pickup. DiMarzio also wanted to avoid the limiting effect that can occur with active pickups when they are played hard. 434 pickup is passive with a lot of headroom, and it responds quickly and accurately to changes in pick attack. A hard pick attack doesn™t cause the signal to flatten out, and picking more softly or rolling the volume control down lets the sound clean up naturally. Like all passive pickups, D Activator pickups require controls with a minimum value of 250Kohms. 500K is the standard all around value, and our 1Megohm tone control is best for long cable runs.
Wiring: 4 Conductor
Output mV: 470
DC Resistance: 11.41 Kohm
Year of Introduction: 2007
Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.