Blemished Shure ULXS14/85 Lavalier Wireless System J1 190839840097

The Shure ULXS14/85 Standard Wireless Microphone System includes WL185 Supercardioid Lavalier Microphone, ULX1 Bodypack Transmitter, and ULXS4 Diversity Receiver.

WL185 Lavalier Microphone
The WL185 Lavalier electret condenser mic was designed for use with a wireless body-pack transmitter. It has a 1.2 meter (4 ft.) cable terminated with a miniature 4-pin mini connector. Included tie clip can be rotated in 90 degree intervals for placement flexibility.

ULX1 Wireless Bodypack Transmitter
The low-profile, highly durable body-pack ULX1 has all the characteristics to meet the demands of high performance. For use with headworn, Lavalier and instrument microphones, as well as guitars and basses. Attaches to belt, waistband or guitar strap with clip for hands-free mobility.

Shure ULXS4 Standard Receiver
The Shure ULXS4 Standard receiver offers an exceptional value in both performance and price, for both working musicians and sound installers. The feature set of the versatile ULXS4 receiver offers a direct path to full, clear audio signals, unencumbered and unattached.

Consumer Alert:

Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website at: www.fcc.gov/cgb/wirelessmicrophones.

RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is

used). Refer to the frequency supplement supplied with the system.

Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)

Audio Frequency Response: 25 to 15,000 Hz, (± 2 dB

NOTE: Overall system frequency response depends on the microphone element.

ULX1 Transmitter Input

Connector: TA4F

Input Configuration: Unbalanced, active

Actual Impedance: 18 kohms with lavalier microphone; 1 Mohms with instrument cable

Maximum Input Level: 10 Vp”p (12 dBV) for 1% THD at minimum gain setting

using 1 kHz signal.

TA4F Connector Pin Assignments: Pin 1: Tied to Ground; Pin 2: Tied to +5 V; Pin 3: Tied to Audio; Pin 4: Tied thru 20kohms Resistor to Ground. (On instrument adapter cable, Pin 4 floats)

Voltage for Remote Power: +5 V supplied to microphone cartridge

ULX1 Transmitter Output

Actual Impedance: 50 Ohms

Nominal Output Level: 20 mW

Maximum Output Level: 30 mW

ULXS4 Receiver Input

Connector Type: Antenna - BNC; Power Input ” IEC 320

Actual Impedance: Antenna 50 Ohms

Nominal Input Level: Antenna - ”95 to ”30 dBm; Power Input ” 15 Vdc

Maximum Input Level: Antenna - +6 dBm (”20 dBm recommended); Power Input - 18 Vdc

Pin Assignments: Antenna Shell = Ground Center = Signal; Power Input - IEC Standard

Voltage for Remote Power: Antenna 12 Vdc, 150 mA maximum

ULXS4 Receiver Output

Connector: High Z Audio; Low Z Audio*

Output Configuration: High Z Audio - Unbalanced (1/4 in.); Low Z Audio - Balanced (XLR)

Actual Impedance: High Z Audio - 3 kohms; Low Z Audio - 22 ohms

Pin Assignments: High Z Audio Tip = Hot Ring/ Sleeve = Gnd Low Z Audio 1 = Ground, 2 = Hot, 3 = Cold

Voltage/Current/PhantomPower Protection?: High Z Audio ” Yes; Low Z Audio ” Yes

Output Level: Microphone Level = Line Level ” 20 dB

Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive

voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output

Transmitter Gain Adjustment Range: 25 dB

Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone): XLR connector (into 600 ohm load): +3.9 dBV (line), ”17 dBV (mic); 1/4 inch connector (into 3000 ohm load): ”2 dBV

Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.

RF Power Output: 30 mW maximum (ULX1)

Dynamic Range: >100 dB, A-weighted

RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)

Image Rejection: 80 dB typical

Spurious Rejection: 75 dB typically

Ultimate Quieting (reference ±38 kHz deviation): >105 dB, A-weighted

System Distortion (reference ±38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical

Power Requirements: ULX1- 9V alkaline battery (8.4 V Nicad optional);

ULXS: 14 - 18 Vdc (negative ground), 550 mA

Battery Life: 8 to 9 hours (with 9V alkaline battery)

Operating Temperature Range: - 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F) NOTE: Battery characteristics may limit this range.

ULX1 Dimensions (H x W x D): 3.86 x 2.68 x 1.10 in. (96.5 x 67 x 26.7 mm)

ULX1 Net Weight: 79 g (2.8 oz.) without battery

ULXS4 Dimensions (H x W x D): 1.72 x 8.56 x 6.52 in. (43 x 214 x 163 mm)

ULXS4 Net Weight: 2 lbs, 5 oz. (1,049 g)

WL185 Lavalier Microphone

• Type: Condenser (electret bias)
• Polar Pattern: Cardioid
• Frequency Response: 50 to 17,000 Hz
• Output Impedance: 1800 ohms
• Sensitivity (1 Pa = 94 dB SPL): -45.5 dBV/Pa
• Maximum Sound Pressure Level: 130 dB SPL
• Output Noise (A-weighted): 28.0 dB SPL
• Dynamic Range: 102.5 dB
• Polarity: Positive pressure on diaphragm produces positive voltage on pins 3 and 4 relative to pin 1.
• Power Requirements: Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc) provided at microphone connector pin 2 relative to pin 1 of a Shure wireless microphone transmitter.
• Dimensions (diameter x height): 0.22" x 0.43"(5.8 x 11 mm)
• Net Weight: 0.7 oz. (21 g) with cable and connector.

Guitar Center's Pro Coverage
Pro Coverage gives you added warranty protection for your gear. Stepping in where the manufacturer's "normal wear and tear" coverage ends, our Pro Coverage program offers you upgraded coverage if your product ever fails Click To Read More About This Product.