Shure PSM 700 P7TRE3 Wireless Personal Monitor System  

Item #: 
  • Write a Review

The wireless personal monitor system from the PSM 700 series offers advanced controls and features that make it easy to quickly locate and lock in the clearest frequency, prevent distortion and minimi... Click To Read More About This Product

We're sorry—we no longer carry this item.

Find a similar product below or contact us for a recommendation of a great alternative.

Call: 866-498-7882 Email or Chat

Recommended Products

The wireless personal monitor system from the PSM 700 series offers advanced controls and features that make it easy to quickly locate and lock in the clearest frequency, prevent distortion and minimize the number of antennas required to send mixes. The PSM 700 P7TRE3 Wireless System consists of the P7T Wireless Transmitter, the P7R Wireless Bodypack Receiver, and gray SCL3 Sound Isolating Earphones. Designed for the demanding audio specifications of live performance, the sleek, low profile design of the SCL3 Earphones combine WideBand microdrivers with incredible isolation for detailed tone across the frequency range.

Consumer Alert:

Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCCs wireless microphone website at:

  • General
  • UHF operation
  • Stereo or MixMode control for custom monitor mixes
  • 32 user-selectable frequencies per system
  • Up to 16 compatible frequencies for 16 different mixes.
  • Frequency compatible with all Shure Wireless systems (country dependent).
  • MPX Stereo audio transmission
  • Switchable high-frequency boost on P7R
  • +4 dBu and ”10 dBV input level select switch on P7T.
  • Electronically balanced, combined 1/4-in. and XLR connectors on P7T can be used with balanced or unbalanced outputs.
  • Volume and Balance dials on the P7R Receiver.
  • Internal linear power supply on P7T, switchable between 120 VAC and 230 VAC.
  • Peak transmitter modulation limiter with fixed threshold and modulation limit indicators.
  • Loop out connectors on P7T for multiple mix setups and easy installation.
  • Tone-Key squelch.
  • Half-rack chassis on P7T complete with mounting hardware.
  • All metal construction on P7T and P7R.
  • Headphone monitor on P7T for local listening.
  • Earphones reduce ambient sound levels by sealing off the ear canal (Earphones sold separately)
  • P7T Wireless Transmitter
  • Built-in audio limiter
  • Internal power supply
  • 1/2 rack space
  • Remotable/combinable antennas
  • LED Indicators: 8-segment input level; Frequency group
  • Operating Controls: Input level knob; Operating mode (Stereo, Mono, MixMode); Earphone volume knob; Channel selector; Group select switch
  • P7R Wireless Bodypack Receiver
  • Frequency locator
  • Dynamic overload protection
  • LED Indicators: Power; Radio Frequency reception; Low battery
  • Operating Controls: Operating Mode (Stereo, Mono, MixMode); Volume knob; Balance knob; Defeatable limiter; High-frequency boost; Channel selector; Group select switch
  • System
    RF Carrier Frequency Range: 524 - 865 MHz (Available frequencies vary, depending on applicable regulations in the country where the system is used)
    Operating Range: 90 m (300 ft.), under optimum environmental conditions
    Audio Frequency Response: 50 to 15k Hz (+0, ”3 dB @1 kHz); earphone dependent
    Image Rejection: 80 dB typical
    Spurious Rejection: 80 dB typical
    Total Harmonic Distortion (@1 kHz): 0.8% typical (Ref. _35 kHz deviation)
    Modulation: FM ±35 kHz deviation (nominal), MPX Stereo
    Channel Separation: 35 dB typical
    Signal-to-Noise Ratio: 80 dB typical (A-weighted)
    Operating Temperature: ”7 Degrees C to +49 degrees C (+20 degrees F to 120 degrees F)
    NOTE: Electrical safety approval is based on a maximum ambient
    temperature of 35degrees C.
    Battery Life: 4”6 hours, volume dependent
    Polarity: P7T audio inputs to P7R audio outputs: Non-inverting; XLR: pin 2 positive with respect to pin 3; 1/4 in TRS: Tip positive with respect to ring

    P7R Wireless Bodypack Receiver
    RF Sensitivity: 0.7V typical
    Image Rejection: 70 dB typical
    Spurious Rejection: 60 dB typical
    Squelch Threshold: 4V typical
    Antenna Input Impedance: 50 ohms typical
    Antenna: External, threaded connector
    Power Requirements: 9 V battery (alkaline recommend)
    Battery Life: 4-6 hours, volume dependent
    Audio Output Connector: 3.5 mm Stereo (Left = tip, Right = ring, Ground = sleeve)
    Minimum Load Impedance: 16 ohms
    Net Weight: 0.52 lbs. (023 kg)
    Overall Dimensions: 1.070" X 2.540" X 3.350" (27.18 X 64.52 X 85.09 mm)

    P7T Transmitter:
    RF Output Power: 100 mW (+20 dBm) typical conducted, U.S.A. and Canada
    (varies with other countries)
    Modulation Limiter: Internal peak limiter (>10:1 compression)
    Antenna: External whip, 50 _ BNC connector
    Power Requirements: P7T: 90”120 VAC, 50/60 Hz; EP7T: 220”240 VAC, 50/60 Hz
    NOTE: This product is not disconnected from the mains power supply when the power switch is in the OFF position.
    Current: 115 mA maximum at 120 VAC; 55 mA maximum at 230 VAC
    Fuse: P7T: 90”120 VAC, 160 mA/250 V (SLO-BLO); EP7T: 220”240 VAC, 80 mA/250 V time delay 5mm X 20mm
    Dimensions: 1-3/4 in X 7-3/4 in X 9-1/2 in. (44.5 X 196.8 X 241.3 mm)
    Net Weight: 3 lb. 4.8 oz. (1.497 kg)

    SCL3 Sound Isolating Earphones
    Frequency Range: 25Hz ” 18.5kHz
    Sensitivity: 115dB SPL/mW (@ 1kHz)
    Impedance: 26 Ohms (@ 1kHz)
    Weight: 28g (.9oz)
    Input Connector: 3.5mm (1/8")
    Cable Length: 62" (157 cm)
One year warranty on wireless mics, mixers, and circuitry products.
2 year warranty on wired mics.
Warranty terms vary. Check with manufacturer for specific product warranty.

  • Customer Reviews
You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.