CONSUMER ALERT
Most users do not need a license to operate this wireless microphone system. Nevertheless,
operating this microphone system without a license is subject to certain restrictions:
the system may not cause harmful interference; it must operate at a low power level
(not in excess of 50 milliwatts); and it has no protection from interference received
from any other device. Purchasers should also be aware that the FCC is currently
evaluating use of wireless microphone systems, and these rules are subject to change.
For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit
the FCC’s wireless microphone website at
http://www.fcc.gov/cgb/wirelessmicrophones.
Professional grade.
The Shure ULXP24D/87 Dual Handheld Wireless Microphone System includes two ULXP4 Diversity Receivers, and two ULX2 Handheld Transmitters fitted with SM87A Mic capsules. Shure ULX Standard UHF systems represent a breakthrough in performance and price for both working musicians and professional sound installers. ULX Professional systems offer more advanced features and controls, including lockable settings and group scan function. Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel.
ULXP4 Wireless Diversity Receiver
The expanded feature set of the ULXP4 wireless receiver, with advanced settings and controls including lockable settings and group scan, offers a direct path to full, clear audio signals. The ULXP4 offers an exceptional value in both performance and price, for both working musicians and sound installers.
ULX2 Handheld Transmitter
The ULX2 Handheld Transmitter features 3-segment battery fuel gauge, frequency and power settings, and control lockout. A backlit LCD shows group and channel.
SM87A Vocal Microphone
The Shure SM87A microphone is a professional-quality, handheld condenser microphone for use in sound reinforcement, broadcasting, and studio recording installations. Its supercardioid polar pattern provides greater rejection of unwanted sound sources, making it ideal for miking individual instruments in a multi-microphone setting or for miking single sources in a reverberant or noisy environment. An integral three-stage wind and pop filter protects against wind and breath noise. Its built-in shock mount reduces stand and handling noise.
With our
Guaranteed Lowest Price, you can be assured of complete satisfaction and the lowest available price, or your money back!
Shure ULXP24D/87 Dual Handheld Wireless Microphone System Features:
- ULXP4 Wireless Diversity Receiver
Automatic Frequency Selection with group scan function
Over 1400 selectable frequencies
Predictive Diversity
5-segment transmitted audio signal strength meter
5-segment RF meter
3-segment transmitter battery fuel gauge
Advanced multi-function LCD displays group and channel
Mic/Line switch
Remotable 1/2-wave antenna
Frequency and volume lockout
XLR and 1/4-inch output
Rugged metal chassis
1/2 rack design
ULX2 Handheld Transmitter
8-9 Hour Battery Life
Power: On/Off Switch, Battery
LED-Green When ON, Red When Battery Low
Three-segment Battery Power Icon
PEAK Icon-Appears When Audio Signal Overloads
Group/Channel Displays
SET Button for Saving Settings
Adjustable Audio Gain Control
Input Attenuation Switch-Select 0dB for Voice/Low Output; 20dB for High Output
4-pin Mini Connector
Battery Cover Unscrews to Expose Battery and Gain Control
9V Battery Included
SM87A Vocal Microphone
Highly directional supercardioid pickup pattern
Controlled low-frequency roll-off
Very low RF and magnetic hum susceptibility
Minimally affected by varying load impedance
Built-in wind and pop filter
Transducer element shock mounted
Rugged construction for outstanding reliability
Field-usable over a wide range of temperature and humidity conditions
Accepts a wide variety of phantom power sources, including DIN 45 596 voltages of 11 and 52 Vdc
Shure ULXP24D/87 Dual Handheld Wireless Microphone System Specifications:
- RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
used). Refer to the frequency supplement supplied with the system.
Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
ULXP4 Receiver Input
Connector: Antenna Power Input
Connector Type: BNC IEC 320
Actual Impedance: 50 Ohms
Nominal Input Level: —95 to —30 dBm 15 VDC
Maximum Input Level: +6 dBm (—20 dBm recommended) 18 Vdc
Pin Assignments: Shell = Ground Center = Signal IEC Standard
Voltage for Remote Power: 12 Vdc, 150 mA maximum
ULXP4 Receiver Output
Connector: High Z Audio; Low Z Audio
Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
ULX2 Transmitter Input
Input Configuration: Unbalanced, active
Actual Impedance: 20 kohms
Maximum Input Level: 10 Vp—p (12 dBV) for 1% THD at minimum gain setting using 1 kHz signal.
ULX2 Transmitter Output
Actual Impedance: 50 Ohms
Nominal Output Level: 20 mW
Maximum Output Level: 30 mW
Pin Assignments: Shell = Ground Center = Signal
Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
Transmitter Gain Adjustment Range: ULX1: 25 dB
Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): +3.9 dBV (line), —17 dBV (mic)
1/4 inch connector (into 3000 ohm load): —2 dBV
Impedance
ULX2 (input): 1 Megohm ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.
RF Power Output: ULX2: 30 mW maximum
Dynamic Range: >100 dB, A-weighted
RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
Image Rejection: 80 dB typical
Spurious Rejection: 75 dB typical
Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 - 18 Vdc (negative ground), 550 mA
Battery Life: 8 to 9 hours (with 9V alkaline battery)
Operating Temperature Range: - 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
NOTE: Battery characteristics may limit this range
NOTE: Bodypack and Handheld Transmitters cannot be used simultaneously
ULXP4 Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.88 in. (43 mm x 214 mm x 172 mm)
ULXP4 Weight: 2 lbs 7 oz. (1105 g)
ULX2/SM87 Dimensions (Length x diameter): : 8.8 x 2 in. (223.5 x 51 mm)
ULX2/SM87 Weight: 9.1 oz. (258 g) without battery
87A Vocal Microphone
Transducer Type: Condenser (electret bias)
Frequency Response: 50 to 20,000 Hz
Polar Pattern: Supercardioid
Output Impedance: Rated at 150 ohms (100 ohms actual +/- 20%)
Recommended minimum load impedance: 800 ohms
Sensitivity (at 1,000 Hz): Open Circuit Voltage: -52.5 dBV/Pa (2.4 mV)
(1 Pa = 94 dB SPL)
Clipping Level (at 1,000 Hz): 1000 ohm Load: -6 dBV (0.5 V)
Maximum SPL (at 1,000 Hz): 140.5 dB (0.25% THD, 1000 ohm load)
Self-Noise (equivalent sound pressure level; measured with true RMS voltmeter): 24 dB typical, A-weighted; 26 dB typical, weighted per DIN 45 405
Dynamic Range: 116.5 dB (maximum SPL to A-weighted noise level)
Signal-to-Noise Ratio: 70 dB at 94 dB SPL (IEC 651) - S/N ratio is difference between 94 dB SPL and product's equivalent self noise (SPL A-weighted).
Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
Power: Phantom Supply Requirement: 11 to 52 Vdc, positive at both pins 2 and 3 Current Drain: 1.0 to 1.2 mA
Connector: Three-pin (XLR) professional audio
Shure ULXP24D/87 Dual Handheld Wireless Microphone System
One year warranty on wireless mics, mixers, and circuitry products.
2 year warranty on wired mics.
Warranty terms vary. Check with manufacturer for specific product warranty.
Get your gear covered!
Now you can get added warranty protection for your new gear. Pro Coverage steps
in where the manufacturer's "normal wear and tear" ends. Our PRO COVERAGE program
offers you UPGRADED COVERAGE if your product ever fails!
Pro Coverage includes:
- Accidental damage protection (new gear only)
- Expedited Repair
- Free Shipping (for returns or repairs)
- 100% Coverage for Commercial Use
- Extended Return Period
- Extended Price Protection
- No Lemon Guarantee
- Free Transfer of Coverage to a new owner
- Repair Costs Covered for up to 3 years from date of purchase
- Repairs Can Be Authorized Toll-Free by Phone or the via the web
