CONSUMER ALERT
Most users do not need a license to operate this wireless microphone system. Nevertheless,
operating this microphone system without a license is subject to certain restrictions:
the system may not cause harmful interference; it must operate at a low power level
(not in excess of 50 milliwatts); and it has no protection from interference received
from any other device. Purchasers should also be aware that the FCC is currently
evaluating use of wireless microphone systems, and these rules are subject to change.
For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit
the FCC’s wireless microphone website at
http://www.fcc.gov/cgb/wirelessmicrophones.
Professional grade.
The Shure ULX Wireless Professional Lavalier System features a ULXP4 Diversity Receiver, a ULX1 Bodypack Transmitter, and the WL185 Lavalier Mic. Shure ULX Standard UHF systems represent a breakthrough in performance and price for both working musicians and professional sound installers. ULX Professional systems offer more advanced features and controls, including lockable settings and group scan function. Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel.
ULXP4 Wireless Diversity Receiver
The expanded feature set of the ULXP4 wireless receiver, with advanced settings and controls including lockable settings and group scan, offers a direct path to full, clear audio signals. The ULXP4 offers an exceptional value in both performance and price, for both working musicians and sound installers.
ULX1 Wireless Bodypack Transmitter
The low-profile, highly durable body-pack ULX1 has all the characteristics to meet the demands of high performance. For use with headworn, lavalier and instrument microphones, as well as guitars and basses. Attaches to belt, waistband or guitar strap with clip for hands-free mobility.
WL185 Lavalier Microphone
The WL185 lavalier electret condenser mic was designed for use with a wireless body-pack transmitter. It has an attached 4 ft. cable terminated with a miniature 4-pin mini connector. The included tie clip can be rotated in 90 degree intervals for placement flexibility.
With our
Guaranteed Lowest Price, you can be assured of complete satisfaction and the lowest available price, or your money back!
Shure ULXP14/85 Lavalier Wireless Microphone System Features:
- ULXP4 Wireless Diversity Receiver
Automatic Frequency Selection with group scan function
Over 1400 selectable frequencies
Predictive Diversity
5-segment transmitted audio signal strength meter
5-segment RF meter
3-segment transmitter battery fuel gauge
Advanced multi-function LCD displays group and channel
Mic/Line switch
Remotable 1/2-wave antenna
Frequency and volume lockout
XLR and 1/4-inch output
Rugged metal chassis
1/2 rack design
ULX1 Wireless Bodypack Transmitter
Three-segment battery fuel gauge
Frequency and power lockout
Flexible 1/4 wave antenna
TA4F mini four-pin input connector
Backlit LCD display shows group and channel setting
Adustable audio gain control
Input attenuation switch (selects 0 dB or -20 dB attenuation)
PEAK icon appears when audio input overloads the transmitter
Power on/off switch
8 hour battery life (9V battery)
300 foot (100m) operating range
WL185 Lavalier Microphone
Cardioid Polar Pattern
Recommended for sound reinforcement applications requiring good rejection of ambient noise and narrow pickup angle
130 degrees pickup angle
Shure ULXP14/85 Lavalier Wireless Microphone System Specifications:
- RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
used). Refer to the frequency supplement supplied with the system.
Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
ULXP4 Receiver Input
Connector: Antenna Power Input
Connector Type: BNC IEC 320
Actual Impedance: 50 Ohms
Nominal Input Level: —95 to —30 dBm 15 VDC
Maximum Input Level: +6 dBm (—20 dBm recommended) 18 Vdc
Pin Assignments: Shell = Ground Center = Signal IEC Standard
Voltage for Remote Power: 12 Vdc, 150 mA maximum
ULXP4 Receiver Output
Connector: High Z Audio; Low Z Audio
Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
Transmitter Gain Adjustment Range: ULX1: 25 dB
Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): +3.9 dBV (line), —17 dBV (mic)
1/4 inch connector (into 3000 ohm load): —2 dBV
Impedance
ULX1 (input): 1 Megohm ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.
RF Power Output: ULX2: 30 mW maximum
Dynamic Range: >100 dB, A-weighted
RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
Image Rejection: 80 dB typical
Spurious Rejection: 75 dB typical
Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 - 18 Vdc (negative ground), 550 mA
Battery Life: 8 to 9 hours (with 9V alkaline battery)
Operating Temperature Range: - 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
NOTE: Battery characteristics may limit this range.
ULXP4 Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.88 in. (43 mm x 214 mm x 172 mm)
ULXP4 Weight: 2 lbs 7 oz. (1105 g)
ULX1 Dimensions (H x W x D): 3.86 x 2.68 x 1.10 in. (96.5 x 67 x 26.7 mm)
ULX1 Net Weight: 79 g (2.8 oz.) without battery
WL185 Lavalier Microphone
Type: Condenser (electret bias)
Polar Pattern: Cardioid
Frequency Response: 50 to 17,000 Hz
Output Impedance: 1800 ohms
Sensitivity (1 Pa = 94 dB SPL): -45.5 dBV/Pa
Maximum Sound Pressure Level: 130 dB SPL
Output Noise (A-weighted): 28.0 dB SPL
Dynamic Range: 102.5 dB
Polarity: Positive pressure on diaphragm produces positive voltage on pins 3 and 4 relative to pin 1.
Power Requirements: Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc) provided at microphone connector pin 2 relative to pin 1 of a Shure wireless microphone transmitter.
Dimensions (diameter x height): 0.22" x 0.43"(5.8 x 11 mm)
Net Weight: 0.7 oz. (21 g) with cable and connector.
Shure ULXP14/85 Lavalier Wireless Microphone System
One year warranty on wireless mics, mixers, and circuitry products.
2 year warranty on wired mics.
Warranty terms vary. Check with manufacturer for specific product warranty.
Get your gear covered!
Now you can get added warranty protection for your new gear. Pro Coverage steps
in where the manufacturer's "normal wear and tear" ends. Our PRO COVERAGE program
offers you UPGRADED COVERAGE if your product ever fails!
Pro Coverage includes:
- Accidental damage protection (new gear only)
- Expedited Repair
- Free Shipping (for returns or repairs)
- 100% Coverage for Commercial Use
- Extended Return Period
- Extended Price Protection
- No Lemon Guarantee
- Free Transfer of Coverage to a new owner
- Repair Costs Covered for up to 3 years from date of purchase
- Repairs Can Be Authorized Toll-Free by Phone or the via the web
