Mesa Boogie M6 Carbine 600W 2x12 Bass Combo Amp  

Item #: 
127474186385887088
  • Write a Review

The Mesa Boogie Carbine bass amplifier delivers an exciting new voice that's super fast and extremely focused. The output section relies on the same time- proven array of custom designed MOSFETs used ... Read More

We're sorry—we no longer carry this item.

Find a similar product below or contact us for a recommendation of a great alternative.

Call: 866-498-7882 Email or Chat

Recommended Products
Overview

The Mesa Boogie Carbine bass amplifier delivers an exciting new voice that's super fast and extremely focused. The output section relies on the same time- proven array of custom designed MOSFETs used in the M-Pulse, Big Block and Titan models, but the preamp and driver section creates a very different feel and attitude.

Up front the tube preamp uses a standard tone control string of Bass, Mid and Treble to shape the basic sound, but the shaping power doesn't stop there. The Mesa M6 Cabine has a Pull Deep feature found on the Bass control that keeps the low end tight and articulate when pushed in or, enhances the sub-lows and adds super-top air when pulled out.

The convenient Pull Deep feature allows you to select two ranges of fundamental for the Bass control. Normal (Pushed In) accentuates tight, percussive bottom that tracks with accuracy and cuts through a mix. Pull Deep (Pulled Out) shifts the low end, enriching the sub-low and extreme-top to create warm, breathing air the whole band can ride on.

The Mesa M6 Carbine also features a Voice control for instant access to global character changes. Here you'll find four iconic and distinctively different sounds and a bypass on a 5 position rotary pot that graphically shows you the EQ curve for each. To the left, positions 1 and 2 dip the midrange in two different places giving you two amazing choices for classic round, warm R&B sounds. Turning right past the 12:00 noon Flat position unveils two variations on the mid-bump theme. Positions 4 and 5 boost adjacent mid regions to create two powerful mid focused sounds that push articulate fingerstyle playing to the forefront of any mix or add the tight drive to Rock. Great Tone doesn't get any simpler.

The bass amp's powerful five-position Voice control gives you all the power of a parametric EQ without the fuss. Voice allows instant selection of four distinctly different EQ curves and Bypass. Choose position 1 or 2 that cuts midrange in two different frequencies for the ultimate warm, scooped R&B vibe. Or boost midrange in specific spots that enhance tight finger-style or Rock work with position 4 or 5. Can also be triggered remotely using the Rear Panel External Switch jacks.

DI Level and Master controls make adjusting your playing volume levels quick and easy on stage. The DI Level features both post and pre Tone control options, with post being the default (pushed in) setting and Pull Pre activating the pre setting that bypasses the entire preamp. A Tuner Mute pull pot is added to the Master Output control for silent tuning in live or studio applications. This feature can also be triggered remotely from the Rear Panel Function Switch jack labeled Mute.

The Rear Panel follows suit with simplicity dictating the layout of the essential features every pro rig should include. Tucked securely between the intake/exhaust vents sit the Function Switch jacks and the speaker outputs. The Function Switch 1/4" jacks provide switch ports to control the Front Panel Voice feature and the Tuner Mute. Connecting any grounding (tip to ground) logic switch here will trigger the desired Voice setting or the mute. This allows settings to be stored under programs in a master external switcher. The speaker outputs uses stage ready Speakon universal connectors which accommodate both standard 1/4" phone type and Neutrik Speakon locking plugs. A Speaker Impedance switch keeps things in the Output section properly matched and allows you to select between 8/4 Ohm loads or switch down to 2 Ohms (critical when loads of 2 Ohms are used) for full power with these low load settings.

To the right of the Mesa Boogie bass amp's air intake vent are the Effects Loop and Direct Output sections. The Direct Output consists of a standard 3 pin male XLR jack and a ground lift for the circuit to chassis ground connection.

The Effects Loop is in series with the main signal and can be bypassed with the switch located above the Send jack. The Tuner Out jack will feed a signal to your outboard tuner and you can use the Front Panel Pull Mute feature located on the Master control to mute the signal for silent tuning. The Mute can also be remote triggered by connecting a grounding footswitch to the Rear Panel Function Switch labeled Mute.

Five 1/4" function switch jacks are provided for remote triggering of the Voice feature and the Tuner Mute allowing you to build programs under a remote switching system for easier access in stage applications.

Features
  • Handbuilt in Petaluma, California
  • 600 Watts @ 4 or 2 Ohms (320 @ 8), Trans-Class Power with 8/4 or 2 Ohm Impedance Switch for optimum Power-to-Load Performance / 8 Power MOSFETs, 1x12AX7
  • Active/Passive Input Switch
  • Vacuum Tube Preamplifier featuring: Gain, Active Bass with Pull Deep, Passive Mids, 5-Position Active Mid-Voicing Switch, Active Treble and Master Volume with Pull Mute
  • Tuner output
  • FX Loop w/True "Hard" Bypass Switch
  • Balanced XLR Line Out with Ground Lift & Front Panel Level Control with Pre/Post Pull switch
  • External Switch Jacks for Tuner Mute and Mid-Voices 1, 2, 4 and 5
  • Two combination Speakon and 1/4" speaker output jacks
Warranty
MANUFACTURER'S WARRANTY
5 Years Transferable parts/labor, 3 Years on Speakers, 6 Months on Tubes


  • Customer Reviews
Loading....

Review Snapshot

by PowerReviews
Mesa BoogieM6 Carbine 600W 2x12 Bass Combo Amp
 
5.0

(based on 1 review)

Ratings Distribution

  • 5 Stars

     

    (1)

  • 4 Stars

     

    (0)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (0)

  • 1 Stars

     

    (0)

Reviewed by 1 customer

Displaying review 1

Back to Top

(19 of 19 customers found this review helpful)

 
5.0

Beast amp in convenient package

By Josh

from Avon, Il

Comments about Mesa Boogie M6 Carbine 600W 2x12 Bass Combo Amp:

This amp isn't cheap for the size, but the reason i decided on buying it was because the sound it gives you is so much richer deeper and fuller than anything else I tried. Plus I had been told by many friends that Mesa was the way to go for build quality and durability. I have had this combo for almost a year and it has yet to disappoint me. I play in a large church but I also play with my metal/hardcore band on the road. This amp handles both duties with ease. I can model it to a smooth warm sound for playing in church, then easily switch over to a deep but aggressive and cutting sound for my band. Not only is the sound quality superb, this beast is WAY louder than the size will tell you. The church I play at holds about 1000 people, and this will fill that room on its own with ease. My friends think there is stage subs or something and are amazed when I tell them its all me. The handle, wheels and small size make it easy to take around with you. This amp just covers all its basses(Get it? ;). No matter what you want out of your amp, I can guarantee this combo will not disappoint.

Comment on this reviewHelp Icon

You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.