The 2-channel Markbass AC 601 Mark Acoustic is a solid-state bass combo amplifier that pumps out 250W of power at 8 ohms. Just because you're playing acoustic bass, doesn't mean you can't rock. The ... Click To Read More About This Product
The 2-channel Markbass AC 601 Mark Acoustic is a solid-state bass combo amplifier that pumps out 250W of power at 8 ohms. Just because you're playing acoustic bass, doesn't mean you can't rock. The Mark Acoustic amplifier boasts a 6" B&C speaker with 1" HF compression driver with custom horn. Channel 1 offers a 3-band EQ, while Channel 2 has a 2-band EQ (low/high) plus Markbass' exclusive Variable Pre-shape Filter.
Adding to your sound choices are 4 reverb effects (Room, Reverb 1, Reverb 2, Hall), and 2 Chorus effects (Chorus 1, Chorus 2) with Gain and Effect Mix level controls. The I/O includes a front input that accepts either a balanced or unbalanced XLR, as well as Neutrik Speakon Combo out jacks for use with 1/4" or Speakon speaker cables, a balanced XLR out, and an Insert point jack for adding external components into the preamp chain on the rear panel. Best of all, the Markbass AC 601 Mark Acoustic is an amplifier that doesn't just work with an acoustic bass or guitar, but with acoustic instruments like mandolins, violins, cellos, banjos, etc.
Solid state preamp and an analog power amp
6" B&C speaker
4 reverbs effects (Room, Reverb 1, Reverb 2, Hall)
2 chorus effects (Chorus 1, Chorus 2)
3-band EQ on channel 1
2-band EQ with Variable Pre-shape filter on Channel 2
Gain and Effect Mix level control on both channels
Line out, Master Control knobs
Input accepts both balanced XLR input or unbalanced
Neutrik Speakon Combo out jacks for use with 1/4" or Speakon speaker cables
Balanced XLR line out
Insert point for inserting external components into the amplifier chain
Ground lift switch to eliminate hum
High frequency compression driver level control on the left side
Works with all acoustic instruments including bass, guitar, mandolin, violin, cello, banjo, etc.
Handle on top for transportation
Dual-sided fiberglass PC boards with lined perforations for high-quality solder connections
Surface-mount components are silicon-sealed to isolate vibrations
Computer-grade pre-assembled ribbon connector cable harnesses and ribbons for noise-free operation
Integrated threaded posts for easy assembly/disassembly and added durability
Rigid 2mm thick aluminium chassis for a long-lasting finish
Impedance: 8 ohms
Speaker size: 1 x 6"
Bass ports: rear
Tweeter: 1" compression driver with custom horn
Power Handling: 150W RMS (AES Standard)
Crossover Frequency: 3.5kHz
Frequency Response: 55Hz to 18kHz
Amp output power
(analog) 250W at 4 ohm / 150W at 8 ohm
Sensitivity: 98 dB SPL
Weight: 19.4 lbs.
Dimensions: 12.3"W x 13"H x 11.2"D
Voltage is factory preset for the U.S.