The Eminence Legend 1058 10" Guitar Speaker has a very meaty tone, but with sparkle, definition and a smooth top-end. Great for blues, country and rock. High power, vintage, seamed cone tonality for guitar. Ideal Vintage alnico Jensen replacement.

Eminence Legend 1058 10 Guitar Speaker Features:

Voice Coil Diameter: 1.5", 38.1mm
Magnet Weight: 16 oz.
Power Rating.: 75W
Sensitivity: 98.7

Eminence Legend 1058 10 Guitar Speaker Specifications:

Nominal Basket Diameter: 10", 254mm
Nominal Impedance: 8 ohms
Power Rating*: 75W
Resonance: 97Hz
Usable Frequency Range: 100Hz-6kHz
Sensitivity**: 98.7
Magnet Weight: 16 oz.

Thiele & Small Parameters
Resonant Frequency (fs): 97Hz
DC Resistance (Re): 7.49
Coil Inductance (Le): 0.56mH
Mechanical Q (Qms): 17.78
Electromagnetic Q (Qes): 1.21
Total Q (Qts): 1.13
Compliance Equivalent Volume (Vas): 26.4 liters / 0.9 cu. ft.
Peak Diaphragm Displacement Volume (Vd): 0cc
Mechanical Compliance of Suspension (Cms): 0.16mm/N
BL Product (BL): 8.0 T-M
Diaphragm Mass inc. Airload (Mms): 17 grams
Efficiency Bandwidth Product (EBP): 80
Maximum Linear Excursion (Xmax): 0.0mm
Surface Area of Cone (Sd): 344.9 cm2

Mounting Information
Recommended Enclosure Volume:
Sealed: Acceptable
Vented: Acceptable
Overall Diameter: 10.11", 256.8mm
Baffle Hole Diameter: 9.13", 231.8mm
Front Sealing Gasket: fitted as standard
Rear Sealing Gasket: fitted as standard
Mounting Holes Diameter: 0.23", 5.7mm
Mounting Holes B.C.D.: 9.6", 243.8mm
Depth: 4.1", 104mm
Net Weight: 4.4 lbs., 2 kg
Shipping Weight: 5.4 lbs., 2.5 kg

Materials of Construction
Copper voice coil
Polyimide former
Ferrite magnet
Non-vented core
Pressed steel basket
Paper Cone
Paper cone edge
Solid composition felt dust cap

* Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
**The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance - LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)