DPA Microphones d:dictate ST4006C Stereo Pair with 4006C Compact Omnis
Write a Review
The ST2011A is a complete DPA 2011A Stereo Pair with two handpicked cardioid microphones, selected on sensitivity within ±1.5 dB making several stereo principles like XY and ORTF easy to obtain.Findin... Click To Read More About This Product
We're sorry—we no longer carry this item.
Find a similar product below or contact us for a recommendation of a great alternative.
The ST2011A is a complete DPA 2011A Stereo Pair with two handpicked cardioid microphones, selected on sensitivity within ±1.5 dB making several stereo principles like XY and ORTF easy to obtain.
Finding its use on numerous stages and recording sessions, the ST2011A exhibits a previously unheard blend of clarity, richness and dynamic range, the 2011As perform close to much more exclusive microphone pairs.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlays.
Included in this kit Two carefully matched 2011A cardioid microphones, sturdy Peli case, holders, and windscreens.
Sensitivity selected pair Superb stage separation and level control All-round workhorses Peli Case transportation and protection
Directional pattern: Cardioid Principle of operation: Pressure gradient, with interference tube Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule Frequency range: 20 Hz - 20 kHz Frequency range, ± 2 dB, at 30 cm: 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB) S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 74 dB(A) Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 137 dB SPL peak Dynamic range: Typ. 117 dB Max. SPL, peak before clipping: 153 dB Switchable attenuator: 0 dB / -20 dB Output impedance: < 200 ohm Minimum load impedance: 2 kohm Cable drive capability: 100 m (328 ft) Output balance principle: Impedance balancing with Active Drive Common Mode Rejection Ratio (CMRR): > 60 dB Power supply (for full specifications): 48 V Phantom power (± 4 V) Current consumption: 2.8 mA Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase Color: Matte black Weight: 164 g (5.8 oz) Microphone diameter: 19 mm (0.75 in) Microphone length: 198 mm (7.8 in) Output voltage, RMS: > 5 V Polarity: +V at pin 2 for positive sound pressure Temperature range: -40 °C to 45 °C (-40 °F to 113 °F) Relative Humidity (RH): Up to 90% Sensitivity selection tolerance (at 1 kHz): ± 1.5 dB