Crown XLS 802D Power Amplifier  

Item #: 
127474181799971616
  • Write a Review

1,050W/ch @ 2 ohms, 800W/ch @ 4 ohms, 500W/ch @ 8 ohms, 1,600W bridged mono @ 8 ohms. Designed to provide the quality, power, and reliability you expect from other Crown amps with many of the same con... Click To Read More About This Product

We're sorry—we no longer carry this item.

Find a similar product below or contact us for a recommendation of a great alternative.

Call: 866-498-7882 Email or Chat

Recommended Products
Overview

1,050W/ch @ 2 ohms, 800W/ch @ 4 ohms, 500W/ch @ 8 ohms, 1,600W bridged mono @ 8 ohms. Designed to provide the quality, power, and reliability you expect from other Crown amps with many of the same controls and features for a much friendlier price.

Features sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use.

Features
  • Features sophisticated protection circuitry
  • 5-way fault indicator
  • Red peak clip LED on each channel
  • Green signal-present LED that flashes when the level is extremely low
  • Detented level controls
  • Mode select switch for stereo or bridged
  • 3-speed fan
  • XLR inputs
  • Touchproof binding post and Speakon outputs
  • All in a rugged steel chassis designed to handle serious road use
Specifications
  • Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V.

    Frequency Response (at 1 watt) 22Hz to 20kHz: +0 dB, ”0.8dB

    Signal-to-Noise Ratio (20Hz to 20kHz)_A-weighted, below rated power: _>98dB. _No weighting, below rated power: _>93dB.

    Total Harmonic Distortion (THD): <0.5%.

    Intermodulation Distortion (IMD):_(60Hz and 7kHz at 4:1) from full rated output to ”40 dB: < 0.3%.

    Damping Factor (8 ohm) 10Hz to 400Hz: >200.

    Crosstalk (below rated power)_at 1kHz: ”76dB. at 20kHz: ”58dB.
    Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced.
    Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.

    AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60Hz, 100 VAC 50/60Hz, 220 VAC 50Hz, and 230-240 VAC

    29 lb.
Warranty
MANUFACTURER'S WARRANTY
3 year, no-fault parts and labor warranty on amps.
3 year warranty for most mics.
1 year warranty for Soundgrabber mic.
Crown Extended Warranty available as an option.


  • Customer Reviews
Loading....

Review Snapshot

by PowerReviews
 
4.5

(based on 21 reviews)

Ratings Distribution

  • 5 Stars

     

    (15)

  • 4 Stars

     

    (3)

  • 3 Stars

     

    (2)

  • 2 Stars

     

    (0)

  • 1 Stars

     

    (1)

Most Liked Positive Review

 

Great Product

I bought a 802 to see how well in would hold up in our house of worship. I tested this Amp on several levels and the 802 worked fantastic. This unit was so good...Read complete review

I bought a 802 to see how well in would hold up in our house of worship. I tested this Amp on several levels and the 802 worked fantastic. This unit was so good and easy to use, we bought 6 more! You an't go wrong with a Crown.

VS

Most Liked Negative Review

 

3rd Crown Failure

We purchased two of these to run our Mackie s410s subwoofers, each in bridged mode. The speakers are 8 Ohm so there should not have been issues. The first one came with a...Read complete review

We purchased two of these to run our Mackie s410s subwoofers, each in bridged mode. The speakers are 8 Ohm so there should not have been issues. The first one came with a non-working channel from the factory. We sent it back and got a replacement. The replacement lost a channel after 4 shows so I replaced it with a QSC PLX3202. The next show the last 802D just died. All the lights out, no power, and not a breaker issue... we daisy chained the subs on the QSC to get through the night. I went ahead and bought another PLX3202. I think these are very low Crown products. But 299 vs 1,100.00 is a large difference in quality - so I'm not trying to compare apples to apples - but I can't afford amp failure in a show.This is one that I would definitely get the added warranty to make this a little less annoying.

Reviewed by 21 customers

Displaying reviews 1-10

Back to Top

Previous | Next »

(3 of 4 customers found this review helpful)

 
3.0

3rd Crown Failure

By tcstx

from Houston, TX

We purchased two of these to run our Mackie s410s subwoofers, each in bridged mode. The speakers are 8 Ohm so there should not have been issues. The first one came with a non-working channel from the factory. We sent it back and got a replacement. The replacement lost a channel after 4 shows so I replaced it with a QSC PLX3202. The next show the last 802D just died. All the lights out, no power, and not a breaker issue... we daisy chained the subs on the QSC to get through the night. I went ahead and bought another PLX3202. I think these are very low Crown products. But 299 vs 1,100.00 is a large difference in quality - so I'm not trying to compare apples to apples - but I can't afford amp failure in a show.This is one that I would definitely get the added warranty to make this a little less annoying.

 
5.0

Growing yp the BIG BOY'S had Crown

By Michael A. White

from Albuquerque,New Mexico

Always knew that Crown was in a league by it's own. So when I had the money I bought two 802's and now I'm getting one more. Like the Man said get then before they go.I'm using one each for High's/Mid's/Low's and got two CE 1000's for back up. Can U say CROWN!!! There are other's out ther, but foe Me it's Crown.Go w/ what Works Good Hunting!!!

(1 of 1 customers found this review helpful)

 
5.0

Great Amp

By Phillip-t5I2v

from USA

let me first start by saying that I use these for my subs. They power them extremely well. I am planing on getting a second one of these amps for my mains. The only problem that I have found, only by reading Crowns site, BEFORE I bought it is that they are not designed to be used with low ohms like bridged at 4 ohms or used at 2 ohms... which I do not use so it works great for me. this amp has never let me down like other amps I have had in the past. the prices on these amps are far lower than they are worth. buy it, as long as you are not the type of person that will daisy chain everything... which is hard on any amp.

(1 of 1 customers found this review helpful)

 
5.0

Outstanding for the price

By Mr. B.-hK_Km

from Milwaukee, WI

If you're playing shows with 5,000+ people, I could understand why you might not give this 5 star ratings, but if you're just going to be using it for personal home use, or personal, small band shows, there's no way you need anymore power... if you think you do then you're either deaf or seeking to become deaf. I can't even turn this thing half way up before my ears can't take anymore. At this level the sound is still crystal clear. Buy it now before they're no longer available!

(1 of 2 customers found this review helpful)

 
3.0

4 ohm bridge???

By WG Audio Group LLC

from detroit mi

bought this to run a pair of 18" subs for our B system thinking that 2100 watts would suffice for medium sized club environments. after 15 minutes the unit went into thermal shutdown. it did cool down and come back online, but after just a few more minutes once again it shut down. take note it was at a moderate level and was not pounded it into clip. needless to say that was the end of the xls802d running @ 4ohm bridge mode. its now used for another application in 8 ohm bridge for mid range and have had no problems, but after checking the specs at crown it is not mentioned anywhere about 4 ohm bridge mode. is it junk? NO...but i have serious doubts about its 4 ohm capability- at least on low end. i still think its a decent amp for the money. just wish it had a higher damping factor but that's why there is such a huge price difference in other crown products. you get what you pay for.

 
5.0

This amp rox

By Lisa

from Dallas, Texas

Crisp, clear sound with solid separation, exactly what I was looking for!

 
5.0

Great amp for the money

By Vic-RQddY

from Brownsburg IN

I have been using my Crown XLS802D for about a month. I have it connected to my Texas Audio pre-amp mixer. I have sampled the output on many genres of music and am satisfied with its overall performance. The dual fans keep this machine running cool. The front interface is simple and to the point. For the applications I use this for I wholeheartedly recommend it.

 
5.0

802D

By cq clemmings

from WI

Basic amp sounds like what you want with right processing. Very clean and simple inside, I bought this to replace Behringer, should last as long. Works at 2 ohms but don't push it on low end, I use B52-4000 for that.

(0 of 2 customers found this review helpful)

 
1.0

Doesnt do near what it says. Very weak

By C. Collins

from Dallas, TX

I bout one of these to run on a carvin sub that was 1600 peak. ran it bridged and it wouldnt push at all hardly without clipping. Had a sound enginneer come in and said this is one of the worst amps crown has prroduced. Crown is a good amp, but this particular model is a flop.

(1 of 1 customers found this review helpful)

 
5.0

CROWN Amps are SOLID!

By DJ TMAQ

from Charlotte, NC

I bought this amp, and doing events with it without a carrying case. After one event, I was pushing my cart (loaded with 2 speakers/turntables/mixer/THIS CROWN AMP) onto an elevator and the wheel caught to gap at the elevator and my cart stopped instantly throwing my mixer and this amp smashing to the marble floor. The fall bent the metal casing this amp is built into. I got home, hook everything up and WOW!! IT STILL WORK AMAZING! No volume or static issues after that nasty fall. This CROWN is durable, and pushes my 2 15' JBL with ease. I also left it on over night after performing all evening and came back to the venue the next day find it running cool and quiet. Don't Hesitate to purchase a CROWN.

Displaying reviews 1-10

Back to Top

Previous | Next »

You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.