Crown XLS 202D Power Amplifier  

Item #: 
127474181798471610
  • Write a Review

The Crown XLS 202D Power Amplifier is designed to provide the quality, power, and reliability you expect from Crown. It boasts many of the same controls and features as other Crown amps for a much fri... Click To Read More About This Product

We're sorry—we no longer carry this item.

Find a similar product below or contact us for a recommendation of a great alternative.

Call: 866-498-7882 Email or Chat

Recommended Products
Overview

The Crown XLS 202D Power Amplifier is designed to provide the quality, power, and reliability you expect from Crown. It boasts many of the same controls and features as other Crown amps for a much friendlier price. 300W/ch @ 4 ohms, 200W/ch @ 8 ohms, 600W bridged mono @ 8 ohms.

The Crown XLS power amp boasts sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; and XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use.

Features
  • Features sophisticated protection circuitry
  • 5-way fault indicator
  • Red peak clip LED on each channel
  • Green signal-present LED that flashes when the level is extremely low
  • Detented level controls
  • Mode select switch for stereo or bridged
  • 3-speed fan
  • XLR inputs; touch-proof binding post and Speakon outputs
  • Rugged steel chassis designed to handle serious road use.
Specifications
  • Performance
    Sensitivity (volts RMS) for full rated power at
    4 ohms: 1.25V

    Frequency Response (at 1 watt) 22Hz to 20kHz: +0 dB, ”0.8 dB

    Signal-to-Noise Ratio (20Hz-20kHz)

    A-weighted, below rated power: >98dB

    No weighting, below rated power: >93dB

    Total Harmonic Distortion (THD): <0.5%

    Intermodulation Distortion (IMD): (60Hz and 7kHz at 4:1) from full rated output
    to ”40dB: < 0.3%

    Damping Factor (8 ohm) 10Hz to 400Hz: >200

    Crosstalk (below rated power): at 1kHz: ”76dB - at 20kHz: ”58dB

    Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced

    Load Impedance: Rated for 4 to 8 ohms per channel in Stereo, 8 ohms in Bridge Mono

    AC Line Voltage and Frequency Configurations: Available (±10%): 120 VAC 60Hz, 100 VAC 50/60Hz, 220 VAC 50Hz, and 230-240 VAC Mode Switch

    Backpanel switch selects Dual or Bridge-Mono mode

    Indicators

    Signal Presence Indicators: 2 green LEDs
Warranty
MANUFACTURER'S WARRANTY
3 year, no-fault parts and labor warranty on amps.
3 year warranty for most mics.
1 year warranty for Soundgrabber mic.
Crown Extended Warranty available as an option.


  • Customer Reviews
Loading....

Review Snapshot

by PowerReviews
 
4.8

(based on 4 reviews)

Ratings Distribution

  • 5 Stars

     

    (3)

  • 4 Stars

     

    (1)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (0)

  • 1 Stars

     

    (0)

Reviewed by 4 customers

Displaying reviews 1-4

Back to Top

 
5.0

great and affordable

By Juan Amaro

from Rittman,ohio

I do have this amp for three years now,dont let the small wattage fool you,althought is only 200watts per channel at 8 ohms still delivers good sound,i use this in combination with my pv 900 for medium size rooms,the crown i set on bridge(600watts) to power my 8ohm 700 watts 18" single sub and no problem at all,the amp is not even at full vol,for better performance use a pa speaker processor.

Comment on this reviewHelp Icon

(8 of 9 customers found this review helpful)

 
5.0

Amazing amps, made a huge difference.

By Mike

from Manassas, VA

For many years I have been a home theater enthusiast and have bought some very high end gear and though I was happy with the sound it still lacked personality. I purchased 3 of these along with 3 DBX 231 EQ's and my system came to life. Bass became very deep and tight, the separation between channels seemed to dissapear and I'm hearing details from my favorite CD's and DVD's that I've never heard before. My only drawback is the fan noice which in very quiet passages can be a bit loud, but put them in a rack or in an equipement room for a home theater and you won't have any problems. Definately try both of these products, you can't go wrong.

Comment on this reviewHelp Icon

(38 of 40 customers found this review helpful)

 
5.0

Its Worth the PRICE!

By DJ Porky

from Los Angeles, CA

I have owned this amplifier for about 6 months now. I use it to power 2 JBL sinle 15's that are rated at 250 watts rms. This amp will not even go past half ways power and the JBL's will be at the fullest volume (concerning quality). I run it at 8 ohms per side, so 200 watts goin to each speaker. I gotta tell you, it's loud enough for an event of about 100-150 people. I have run it strong for about 6 hours maximum and no overheating at all. Great amplifier, even for the price.

Comment on this reviewHelp Icon

(24 of 24 customers found this review helpful)

 
4.0

nice amp

By drummerdude

from West Bend, Wi

This amp was great. I borrowed it from a friend to run monitors at a gig. I gave it a lower rating on features because it didn't have parallel imputs, which I really needed at the gig. I was able to figure something else out. It ran on 4 ohms a side for about 2 hrs, and it sounded so crystal clear. I have a behringer ep1500 for mains and it is pretty good too. Will definitely be buying a crown amp in the future. This was my first crown experience, and won't be the last!

Comment on this reviewHelp Icon

Displaying reviews 1-4

Back to Top

You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.