Crown remains at the front of the power amp pack with their XLS Series!

840W/ch @ 2 ohms, 600W/ch @ 4 ohms, 380W/ch @ 8 ohms, 1,680W bridged mono @ 4 ohms, 1,200W bridged mono @ 8 ohms. Designed to provide the quality, power, and reliability you expect from other Crown amps with many of the same controls and features for a much friendlier price.

Features sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use.

With our Guaranteed Lowest Price, you can be assured of complete satisfaction and the lowest available price, or your money back!

Crown XLS 602D Power Amplifier Features:

Features sophisticated protection circuitry
5-way fault indicator
Red peak clip LED on each channel
Green signal-present LED that flashes when the level is extremely low
Detented level controls
Mode select switch for stereo or bridged
3-speed fan
XLR inputs; touchproof binding post and Speakon outputs
All in a rugged steel chassis designed to handle serious road use
3-year no-fault warranty

Crown XLS 602D Power Amplifier Specifications:

Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V.
Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, —0.8dB
Signal-to-Noise Ratio (20 Hz to 20 kHz)_A-weighted, below rated power: _>98 dB. _No weighting, below rated power: _>93 dB.
Total Harmonic Distortion (THD): <0.5%.
Intermodulation Distortion (IMD):_(60 Hz and 7 kHz at 4:1) from full rated output to —40 dB: < 0.3%.
Damping Factor (8 ohm) 10 Hz to 400 Hz: >200.
Crosstalk (below rated power)_at 1 kHz: —76 dB. at 20 kHz: —58 dB.
Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced.
Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.
AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC
29.0 lbs.