Legendary Crown quality at an easy price.

The Crown XLS 202D Power Amplifier is designed to provide the quality, power, and reliability you expect from Crown. It boasts many of the same controls and features as other Crown amps for a much friendlier price. 330W/ch @ 2 ohms, 300W/ch @ 4 ohms, 200W/ch @ 8 ohms, 660W bridged mono @ 4 ohms, 600W bridged mono @ 8 ohms.

The Crown XLS power amp boasts sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; and XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use.

With our Guaranteed Lowest Price, you can be assured of complete satisfaction and the lowest available price, or your money back!

Crown XLS 202D Power Amplifier Features:

Features sophisticated protection circuitry
5-way fault indicator
Red peak clip LED on each channel
Green signal-present LED that flashes when the level is extremely low
Detented level controls
Mode select switch for stereo or bridged
3-speed fan
XLR inputs; touch-proof binding post and Speakon outputs
Rugged steel chassis designed to handle serious road use.
3-year no-fault warranty

Crown XLS 202D Power Amplifier Specifications:

Performance
Sensitivity (volts RMS) for full rated power at
4 ohms: 1.25V
Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, —0.8 dB
Signal-to-Noise Ratio (20Hz-20kHz)
A-weighted, below rated power: > 98dB
No weighting, below rated power: > 93dB
Total Harmonic Distortion (THD): < 0.5%
Intermodulation Distortion (IMD): (60Hz and 7kHz at 4:1) from full rated output
to —40dB: < 0.3%
Damping Factor (8 ohm) 10Hz to 400Hz: >200
Crosstalk (below rated power): at 1 kHz: —76 dB - at 20 kHz: —58 dB
Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced
Load Impedance: Rated for 4 to 8 ohms per channel in Stereo, 8 ohms in Bridge Mono
AC Line Voltage and Frequency Configurations: Available (±10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC Mode Switch
Backpanel switch selects Dual or Bridge-Mono mode
Indicators
Signal Presence Indicators: Two green LEDs