Skip to main content Skip to footer
Call and save on most brands call 866 498 7882

Crest Audio CD 3000 3000W Power Amplifier

Item #: 
127474181824971736
  • Write a Review

The CD 3000 3000W Power Amplifier combines a linear power supply and a Class D output to deliver Crest power in a compact and cost-effective package. The CD 3000 is very versatile, whether powering ni... Click To Read More About This Product

We're sorry—we no longer carry this item.

Find a similar product below or contact us for a recommendation of a great alternative.

Call: 866-498-7882 Email or Chat

Recommended Products
Overview

The CD 3000 3000W Power Amplifier combines a linear power supply and a Class D output to deliver Crest power in a compact and cost-effective package. The CD 3000 is very versatile, whether powering nightclub systems or high school gymnasiums.

A traditional linear power supply is used in the CD Series. Because of the efficiency of the switching output stage, the transformer does not need to be big or heavy. This gives the CD Series an advantage in delivering huge power in a compact package. The efficiency of the output stage also gives the power supply the ability to handle heavy duty cycles without compromising sonic integrity.

Crest Audio's engineering has also maintained sonic quality while incorporating the advantages of a switching output stage. High-power Class-D topology is the key to its efficiency and low operating temperature. An additional advantage to this design is the amount of power needed over time. This power amplifier will dramatically reduce the number of kW/hr needed for operation.

FEATURES

8 Ohm Stereo - 800 W
4 Ohm Stereo - 1500 W
2 Ohm Stereo - 1800 W
8 Ohm Bridged - 3000 W
Dramatically reduced net weight
Linear power supply / Class D output stages
Very low current draw
Latest generation of high-speed, mosfet output devices
Cooled by variable-speed fan with back-to-front airflow
Inputs: balanced female XLR, 1/4" TRS combi jacks
Outputs: Speakon and five-way binding posts
Mode selector switch for stereo, parallel and bridged-mono operation
Ground-lift switch and rear panel circuit breaker
Recessed, stepped attenuators with removable knobs
16-gauge steel chassis, cast aluminum front panel
TourClass protection circuits
ACL (Active Clip Limiting) prevents speaker damage by providing gentle gain reduction when signal approaches the clipping threshold
IGM (Instantaneous Gain Modulation) monitors speaker loads to detect conditions that may over-stress output devices, allowing safe operation into nominal 2 Ohm speaker loads
AUTORAMP gradually increases gain to the attenuator level-settings when the amplifier is turned on, preventing abrupt turn-on levels
Other protection features include: short circuit, DC voltage, comprehensive thermal management, current in-rush turn-on/off transient and sub/ultrasonic input
Five-year warranty

SPECIFICATIONS
Model: CD 3000
Stereo Power 8 Ohms: 800 Watts
Stereo Power 4 Ohms: 1500 Watts
Stereo Power 2 Ohm: 1800 Watts
Bridged Power 8 Ohm: 3000 Watts
Maximum output voltage: 85V rms
Frequency response 1W @ 8 ohms: 20Hz”20khz, +/-1db
Power bw rated power @ 4 ohms, 1% THD+N: 20Hz”20khz, +/-1db
THD + N: <0.2% rated power @ 4 ohms, 1khz power @ 8 ohms
Imd; SMPTE/DIN 4:1 (60 Hz / 7 khz): <0.35% @ -3 db below rated
Damping factor: 400:1 @ 8 ohms (20 Hz to 100 Hz)
Input CMRR: >60db @ 1khz
Gain / input sensitivity @ 4 ohms: Selectable: x20, x40, or .775 V for full rated output power
Input impedance: >20kohms balanced, >10kohms unbalanced
Hum and noise: > -100db, A-weighted below rated power @ 4 ohms
Crosstalk: > -60db below max rated power (1khz)
Class: D
Power supply: Linear with toroid transformer
Circuit breaker rating (120V/230V): 20A /12A
Current draw (120VAC) 1/8 power, 4 ohms: 7.0A
1/3 power, 4 ohms: 14.0A
At idle: 1.5A
Thermal emissions 1/3 Power, 4 ohms BTU / hr: 1024
Cooling: Back to front via variable speed DC fan
input connectors: balanced female XLR, 1/4" TRS, unbalanced 1/4" TS on Neutrik combo connectors
output connectors: Five-way "touch-proof" binding posts and Neutrik Speakon connectors (which presents
both outputs on the A Speakon for bi-amplified applications)
controls: front panel: twin recessed stepped attenuators, power switch
rear panel: signal ground-lift, mode select, gain select, circuit breaker
LED indicators: signal level (5 element bargraph), protect, active, ACL / IGM
Construction: 16-gauge steel chassis, cast aluminum front panel - optional handles available
Dimensions (W x H x D): 19" x 3.5" x 15.375" (483 x 89 x 391 mm)
Weight: 41.4 lb (21 kg)
  • Customer Reviews
Loading....
You are changing the Ship-To country.

Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.