The U853PMW cardioid condenser hanging microphone comes equipped with a wall/ceiling plate power module for permanent installation in a standard, single-gang electrical box. The phantom-powered microp... Click To Read More About This Product
The U853PMW cardioid condenser hanging microphone comes equipped with a wall/ceiling plate power module for permanent installation in a standard, single-gang electrical box. The phantom-powered microphone features UniGuard innovations that offer unsurpassed immunity from radio frequency interference. It accepts interchangeable elements, available in cardioid, hypercardioid, omnidirectional and UniLine line cardioid polar patterns. Its 80Hz low-cut UniSteep filter reduces pickup of low-frequency ambient noise.
Designed for suspension over choirs, instrumental groups, and theater stages
Superior off-axis rejection for maximum gain before feedback
UniGuard RFI-shielding technology offers outstanding rejection of radio frequency interference (RFI)
UniSteep filter provides a steep low-frequency attenuation to improve sound pickup without affecting voice quality
Accepts interchangeable elements to permit angle of acceptance from 90 degrees to 360 degrees
Low-profile design with low-reflectance finish for minimum visibility
Operates on battery or phantom power
ELEMENT: Fixed-charge back plate, permanently polarized condenser
POLAR PATTERN cardioid
FREQUENCY RESPONSE: 30-20,000Hz
LOW FREQUENCY ROLL-OFF : 80Hz,
OPEN CIRCUIT SENSITIVITY:”39dB (7.9 mV)
re 1V at 1 Pa
IMPEDANCE: 200 ohms
MAXIMUM INPUT SOUND LEVEL: 128dB SPL,
1kHz at 1% T.H.D.
DYNAMIC RANGE (TYPICAL): 102dB, 1kHz at Max SPL
SIGNAL-TO-NOISE RATIO: 68dB, 1kHz at 1 Pa
PHANTOM POWER REQUIREMENTS: 11-52V DC, 4 mA typical
SWITCH: Flat, roll-off, 0dB/+10dB gain setting
WEIGHT (microphone): 0.5 oz (14g)
WEIGHT (power module) : 3.4 oz (97g)
DIMENSION (microphone): 1.34" (34mm) long, 0.48" (12.2mm) diameter
DIMENSION (power module): 2.80" (71.0mm) H x 4.55" (115.5mm) W x 1.42" (36mm D OUTPUT CONNECTOR (power module):
CABLE: 25.0' (7.6m) long (permanently attached to microphone), 0.13" (3.2mm) diameter, 2-conductor, shielded cable with TA3F-type connector
ACCESSORIES FURNISHED: AT8153(WH) two-stage foam windscreen; AT8451(WH) steel hanger; AT8534 wall/ceiling plate power module; AT8438 5/8"-27 stand adapter
AUDIO-TECHNICA CASE STYLE: M12
GUITAR CENTER'S PRO COVERAGE
Pro Coverage gives you added warranty protection for your gear. Stepping in where the manufacturer's "normal wear and tear" coverage ends, our Pro Coverage program offers you upgraded coverage if your product ever fails Click To Read More About This Product.
Our product catalog varies by country due to manufacturer restrictions. If you change the Ship-To country, some or all of the items in your cart may not ship to the new destination.